Parts

85mm Analog Tach for Predator/212/420/670/Clone 0-8000 Tachometer Predator 670 Warning: Harbor Freight uses many different suppliers to make their ...

Pair of studs for Champion Shaft Rockers - GX200 and GX390.

If you have a Predator V-Twin 670cc 22hp engine from Harbor Freight, you know just how cheap the factory cable clamps are. Our billet clamps are ma...

24mm Bored Carb for the GX390 & 420/440 Clones ***This is an advanced product that requires advanced knowledge of carburetors to setup and tune...

Performance Air Filter & Billet Adapter Our performance air filter & billet aluminum adapter fits the stock GX340/GX390 & Clone carbs.A...

Replacement air filter box for our 420/459cc kits. No gaskets or hardware included.

32mm Billet Intake Manifold / Adapter Our Billet Intake Manifold / Adapter allows you to easily mount a Mikuni or Keihin style carburetor to your G...

 Isolator With Pulse Fitting for GX390 Clones Fits Most GX390/Clones, 420s, 440s,& 460s. Does NOT fit Duromax engines, 625s or V-Twins.

Intake Gaskets for GX340/GX390 & Clones Includes 3 OEM Intake Gaskets (2pc Cylinder Head to Isolator & Carb & 1pc Carb to Airbox) Fits ...

Exhaust Gasket OEM Exhaust Gasket on our GX440 Clones Also fits GX340, GX390 & GX420 Clones

Multi-Layer Steel Headgasket - .020" - GX390 & Clones Multi Layer Steel Performance Headgasket for our GX460 Clone engines. 92mm Diameter .020...

Side Cover Gasket - 10 Bolt OEM Crankcase Side Cover Gasket 10-Bolt Style exclusive to our 440cc Engines Will NOT fit 7-bolt blocks!  

Stepped Exhaust Flange for GX390, RX460 & Clones Our exhaust flanges are cut from .250" thick mild steel and CNC machined with a step in them t...

Stepped Exhaust Flange for Predator V-Twin Our Predator V-Twin stepped exhaust flanges are cut from .250" thick mild steel plate and will fit 1" st...

Our Engine Hold Downs allow you to adjust your belt tension and front to back engine positioning much easier than using carriage bolts. These bille...

Dont want to deal with doing your own wiring? We have pre-made 9ft wire harnesses available for you to purchase! The harness includes a mount for y...

Dont want to deal with doing your own wiring? We have pre-made 9ft wire harnesses available for you to purchase! The harness includes a mount for y...

Replacement 5-Wire Keyswitch  2 Keys IncludedSwitch sends a constant ground when the key is in the OFF position.

This Keyswitch Mount is compatible with our 5-wire keyswitch & wiring harnesses.

Billet V-Belt Pulley for use with 780R Clutch & Starter/Gen Our Billet V-Belt Pulleys are CNC machined in-house from 6061 Aluminum and setup fo...

Is your Yamaha Driven/Secondary Clutch worn out and in need of replacement? This kit comes with everything you need to replace your old worn second...

7” Low Profile Primary Drive Clutch (780R) Looking for a clutch for your Big Block Swap? The 780 Clutch is very low profile and will fit in the tig...